LED Fog Lights BMW F750GS-BMW F850 GS incl. MotoBozzo-Switch

BWM F750GS LED -BMW F850 GSFog lights with MotoBozzo-Switch-2 Electronic Control via Mini Pushbutton
The new LED fog light set on the BMW F750GS-BMW F850 GS in quick assembly technology.

As holder serves a VA holder 2-parts, which is easily screwed to the existing panel holes.

An installation above or below is possible, if a mounted crash bar should be in the way.

The supplied wiring harness is perfectly fitting and completely prefabricated to simplify installation.

The special accessory connector prepared by BMW is found at the top right above the speedometer. In this our BMW cable plug will be plugged, and done.

Thus, no further cables are connected to the BMW F750GS-BMW F850 GS.

There is no need for further soldering or cable tapping and no connection to the battery or a flying fuse is required.

Switched by MotoBozzo-Switch-2 electronics:
This is controlled by a mini button, which individually can be glued on with super-strong 3M adhesive pad.

Thus, if the button is mounted as in the example photo, it can be switched at any time without having to take your hands off the handlebar.

Data LED projector lamp:
• Power / Power 12V, 6W
• Power Consumption / Consumption 12V, 0.5A
• LEDs u. Type 1 piece Osram OBF LED
• Fastening Points / Fastening Points 2 M6
• Lumen 520lm +/- 80lm
• Approval ECE, SAE, EMC
• Ventilation / Ventilation Membrane
• Material Housing / Material Housing Aluminum / Alloy
• Material Lens / Material Front Lens PC hardened / hard coated
• Temperature range / operation range -40 - + 80 ° c
• Protection Class / IP Classification IP6K9K / IP68
• Aluminum housing, black powder-coated and structured
• Corrosion protection for 480h salt spray
• extremely compact design
• ECE, SAE, EMC approved

New generation 70 mm LED fog lights with integrated control unit.
With only 6 Watt of power consumption super bright, additional wiring harnesses for an external controller will cease to apply.

Nitto Denko Air Cap ventilation.
Clear light / dark border and concentrated illumination without light scattering.
Very small installation depth (55 mm).

Function MotoBozzo-Switch-2 Electronics:
After switching on the ignition, the lamps switch on automatically.
Now the lamps can be switched off or switched on again by briefly pressing them once.

If it is desired that the lamps are switched off after starting, simply pull off the purple wire on the plug-in and instead connect the prepared green wire.

Regardless of which switching state was last selected, the lamps always switch on when they are switched on (delivery status purple wire inserted), thus forcing in forgetting is excluded.
This can be changed by switching, then the lamps are always after switching on the ignition first switched off (optionally repluggable, green wire).

These lights switched on by day increase your safety, because you are seen much better as a motorcyclist.

No TÜV-demonstration / registration required, as LED lamps with E-mark provided.

Supply of delivery:
2 VA mounts with 2 LED fog lamps, pre-assembled
1 piece wiring harness, MotoBozzo-Switch-2, mini pushbutton and BMW plug, pre-assembled
1 illustrated assembly instructions