MV Handelbar Adapter BMW R1200RS LC and R1250RS LC

MV handlebar adapter for BMW R1200RS LC and R1250RS LC

The sophisticated and elaborately milled adapters for your for BMW R1200RS LC and R1250RS LC bring the handlebars 35 mm closer and 20mm higher and thus ensure a more significant improvement in sitting position.

This results in a natural ergonomic and a healthier sitting position.


The modification takes only about 10 minutes. The original GPS screws from BMW will be used.
At the same time, our adapters cover former handlebar mount from an optical point of view.

All cables are long enough for your BMW R1200RS LC and R1250RS LC. But the clutch line is laid. It is removed from the coupling container without any leakage from the liquid. Then pull out the cable from below and lay it back up and again tighten it. In the lower part is a little hidden cable tie that also needs to be removed.

A hint from us:
If you believe to achieve the same effect with the R1200R Handlebar, please note that the handlebar does not come closer but away from the driver by another 10 mm. Thus, unnecessary cost of approximately 300,00 Euro occure for a modification which does not bring the desired effect.

The adapters are anodised to match the original.
In case you have carried out this modification, you also can add our adapters for the BMW R1200R (article no. 901444) additionally and thus achieve a better sitting position.

All MV accessories were assembled and tested at original motorcycles - without foreign modifications.

Available from now on: Electrically adjustable footrest and handlebars with a push of a button while driving.