BMW R 1200/1250 R-LC LED fog lamp set (Osram lamp chip) new generation including MotoBozzo switch

New generation 70mm LED fog light with integrated control unit.

The ventilation system of the 2nd generation has been further optimised and equipped with a Nitto Denko Air Cap. Thus the headlight now also meets the highest requirements of IP68 and IP6K9K. The excellent illumination with a sharp cut-off line, the low power consumption of only 6 watts and the compact dimensions are decisive features for this modern LED fog light.

• extremely compact headlamp
• excellent illumination with sharp cut-off line
• 9 - 33 V
• 5950K +/- 350K
• H8 / H11 compatible plug polarity independent
• 480h salt spray test
• integrated controller
• Aluminium housing
• hardened polycarbonate disk
• available in chrome and black
• Nitto Denko Air Cap Ventilation
• ECE and SAE approval

BMW R 1200 R-LC LED fog light set including MotoBozzo switch

Here you can see the mounted fog light set on the BMW R 120071250 R-LC. As brackets here are 2 VA holding arms and 2 plastic coated VA lamp sheets for the lamps, which are simply mounted to existing holes in the frame.
These fog lights provide optimum support for the existing headlights, as they illuminate the side strip perfectly and provide excellent illumination in front of the front wheel. The supplied wiring harness is pre-assembled to simplify installation.
The MotoBozzo switch is controlled by the headlight flasher button, so you can change gears at any time without taking your hands off the handlebars. A separate toggle switch on the handlebars is therefore not necessary!
The MotoBozzo-Switch control cables are simply connected directly to the headlight plug/bulb and to an ignition plus, there is no need to lay cables to the headlight flasher button!

Function MotoBozzo-Switch control:

After switching on the ignition, the lamps turn on automatically.
Now the lamps can be switched off or on again by 2 x short flashes (click-click).
The operating status is indicated by a green LED.
If it is desired that the lamps are switched off after starting, simply disconnect the prepared purple wire and connect the green wire instead ;-).

These lights, switched on during the day, increase your safety, because you are much better seen as a motorcyclist!

Scope of delivery:
2 plastic-coated VA-holders including 2 pieces of LED fog lamps with 70 mm diameter.
1 wiring harness with relay, MotoBozzo-Switch and separate fuse ( prewired )
1 illustrated assembly instruction